The Al Medinat Terraformation Tower (1) PREPAINTED (sand) PREORDER is a set of 8 HDF sections designed to be attached to a 3" diameter Tube from your favorite chips (available separately at your convenience store), and a set of printed stickers to cover the tube sides. Dedicated for Infinity the Game by Corvus Belli.

It is compatible with other buildings of Al Medinat series.

There are two 8cm tall ground sections designed to fit over the bottom ring of the tube, fitting Al Medinat Walls directly

There are 6 various size pieces designed to fit the tube at any other height. You can arrange them in any pattern you see fit, or even combine several sets to create distinctly different towers.

We put great effort to make the graphics on these sections to look good either side up, so you can angle the sides down and allow for more area for models up on the tower, or angle them up to just block these long high firelanes while not leaving these Morans too many annoying places to hide!

Al Medinat Qubbas fit on top.

Video

Main colour: SAND

Height (Whole Tower): 23,3cm / 9,1in
Length (Whole Tower): 14,7cm / 5,7in 
Width (Whole Tower): 16,5cm / 6,5in

Height (single piece): 4cm / 1,6in - 6cm / 2,3in - 8cm / 3,15in
Length (single piece): 6,7cm / 2,6in - 9,7cm / 3,8in 
Width (single piece): 4cm / 1,6in - 5,5cm / 2in

This model is delivered as a pack, unassembled and PREPAINTED. 
The parts of the model are designed to slot together in a way that enables a quick and easy assembly. It is necessary to glue some parts of the model - use PVA (white) glue. Every model is cut from one or more panels of HDF (high-density fiberboard) of 3mm.

Attention: Before taking the elements out make sure they are fully cut. There are minor connections that prevent them from falling out.